Gibson GCG91226XA Manual de usuario descargar pdf (Pagina 9)

Hob - Daily use

WARNING!

Refer to Safety chapters.

Ignition of the hob burner

Always light the burner before you

put on the cookware.

WARNING!

Be very careful when you use open

fire in the kitchen environment. The

manufacturer declines any

responsibility in case of the flame

misuse.

The spark generator can start

automatically when you switch on

the mains, after installation or a

power cut. It is normal.

In the absence of electricity you

can ignite the burner manually.

Ignition of a hob burner with the

thermocouple

• For manual ignition put the flame near the

burner. Push the knob for the hob down

and turn it counterclockwise to the

maximum gas flow position .

• For ignition with spark generator button

push and hold the spark generator button

. At the same time push the knob for the

hob down and turn it counterclockwise to

the maximum gas flow position

.

Release the spark generator button when

burner lights.

Keep the knob for the hob pushed for equal or

less than 10 seconds to let the thermocouple

warm up. If not, the gas supply is interrupted.

Adjust the flame after it is regular.

WARNING!

Do not keep the knob pushed for

more than 15 seconds. If the

burner does not light after 15

seconds, release the knob, turn it

into the off position and try to light

the burner again after minimum 1

minute.

If after some tries the burner does

not light, check if the crown and its

cap are in the correct position.

If the burner accidentally goes out,

turn the knob to the off position

and try to light the burner again

after minimum 1 minute.

Burner overview

A

B

D

C

C

D

A

B

A. Burner cap

B. Burner crown

C. Ignition candle (if applicable)

9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Comentarios a estos manuales

Sin comentarios