Gibson GCG91226XA Manual de usuario descargar pdf (Pagina 23)

Flexible nonmetal pipes connection

If you have an easy access to the connection,

you can use a flexible pipe. The flexible pipe

must be tightly attached by clamps.

In installation always use the pipe holder and

the gasket. The flexible pipe can be applied

when:

• it can not get hotter than room

temperature, higher than 30 °C,

• it is not longer than 1500 mm,

• it has no narrowing anywhere,

• it is not twisted or tighten,

• it does not get in touch with sharp edges or

corners,

• it's conditions can be easily checked.

When checking the flexible pipe make sure:

• it does not show cracks, cuts, marks of

burnings on the two ends and on its full

length,

• the material is not hardened, but shows its

correct elasticity,

• the fastening clamps are not rusted,

• expired term is not due.

If one or more defects are visible, do not

repair the pipe, but replace it.

WARNING!

When installation is complete,

make sure that the seal of each

pipe fitting does not leak. To check

the seal use a soap solution, not a

flame.

The gas supply ramp is on the rear side of the

control panel.

WARNING!

Before you connect the gas,

disconnect the appliance from the

electricity supply or switch off the

fuse in the fuse box. Close the

primary valve of the gas supply.

Adjustment to different types of gas

WARNING!

Let only an authorized person do

the adjustment to different types of

gas.

Check the table in chapter

"Product descriptions" to see the

initial gas of your appliance.

If the appliance is set for natural

gas you can change it to liquid gas,

with the correct injectors.

If the appliance is set for liquid gas

you can change it to natural gas,

with the correct injectors.

The gas rate is adjusted to suit.

WARNING!

Before you replace the injectors,

make sure that the gas knobs are

in the Off position. Disconnect the

appliance from the electrical

supply. Let the appliance cool

down. There is a risk of injury.

The appliance is set to default gas.

To change the setting choose a

pipe holder from the list. Always

use the gasket sealing.

A CB

A. Gas connection end

B. Natural Gas pipe holder

C. LPG pipe holder

Hob injectors replacement

Replace the injectors when you change the

gas type.

1. Remove the pan supports.

2. Remove the caps and crowns of the

burner.

3. Remove the injectors with a socket

spanner 7.

4. Replace injectors with the ones necessary

for the type of gas you use.

23

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

Comentarios a estos manuales

Sin comentarios